View Full Version : MKIV Technical
- Need Factory Spec on Cam degree!
- Stock valvetrain
- Sealing Oil Pans
- electronic TTC conversion
- BCC install and now low boost!
- What does a new AC compressor cost?
- Battery relocator kit questions???
- Replacing Radiator! Got your answer RIGHT here!
- Did my FMS today and found something interesting!
- PITA Mystery Coolant Leak
- flywheel toasted??
- Front mount intercooler in a tt
- Weird Stalling??
- Stock hood with no bracing use as pin on?
- auto TT tranny
- After VPC Install help
- HELP! attn Larry.
- Car launches real lazy until 60ft Mark..(Auto Related?)
- 18x13 need some help
- do BCC's die?
- unplugged pass. airbag..?
- wiring question
- Battery Question and short block...
- Knocking or not... AEM EMS log (only for AEM EMS users)
- apex'i power FC
- High Oil Pressure!!!!
- RPS header comparison.
- Fuel pressure problem
- Targa Top
- Fuse, Relay talk
- Brake?
- Sequential or True twin when spraying?
- Specifications of the J-Spec
- Installed VPC & GCC NOW PROBLEM
- Downpipe with stock exhaust?
- Loss of Compression/Power...and "Ping"ing
- boost problem
- which plugs for spray
- Jap spec to US/EUR spec conversion
- OBD1 vs. OBDII
- High mileage Matinence
- tein s tech springs
- PLEASE HELP! Rough Idle when warm
- Auto Tranny problem??
- What should I set my FP to?
- smoke coming out?
- Supra to GM Transmission
- GA Fuel System Pics/Instructions?
- How often do bearing go??
- Old '93 thru '96 Taillight Swap to New '98 Taillight Lamp Failure Sensor Fix
- New Downpipe Installed....Need Help With a Weird Problem...
- Maximum tire size on stock wheels?
- jpec 2jzgte oil pan problem
- Getrag shifter tower
- TRD hood plus TRD strut tower brace
- Car / Turbos are fuked need some help
- GA Fuel-rail to injector fitting needed?
- Fit 8.5" Work Equips need H&R 20mm spacer! help
- Best single turbo boost controller, AVC-R question on single Turbo
- PHR Dpipe and Midpipe Question, bracing opinion, rattling issue
- Noise Help
- F-body guy here, with a couple questions....
- Pressure sensor/Air flow wire
- Identifying Turbo Specifics
- oil pressure sending unit removal tool?
- how to tell the difference ??(valve stem seal or turbo seal prob?)
- Bad Rattling when pulling away/ and when moving wheels - HELP
- Off idling...*HELP*
- Head gasket 1.0 VS 2.0 mm for engine with T78?
- failed emissions
- Apexi S-AFC tuning
- stock fuel pump - max flow?
- VPC & S-AFC vs. VPC & GCC
- powerhouse people, downpipe brace needed??
- Will HKS midpipe fit Powerhouse (PHR) Downpipe
- Engine warning light
- OEM 02 Sensor
- MissFire on JDM Need Help!!
- two BOV install question
- boost boost and no boost
- cam journals chewed up after rod bearing failure
- Help: Misfire due to injector wire
- Problem with boost on 94 tt
- AEM wideband help please
- Cam Gears, Timing, and BTDC
- Dual 341 Walbro Flow Rates
- OVERHEATING please help!!
- More POWER with NO2??? advanced question - help!
- Dyno w dual stock pumps, lean up top on Dyno, help
- Totaly disabling REAR lights
- Please read I need help with single turbo auto
- car wont start
- Max Flow/Max RWHP for Nippon denso 720 CC injs?
- Idle with 720's and VPC/GCC
- Automatic transmission question
- Stripped DP bolt (upper turbo one) HELP!
- Help : Control Panel blew out
- How to check coil packs? Car stalling...
- How to install pad spacers?
- Check Engine Light After Fuel Install...HELP!
- chattering sound from flywheel??
- No top end...TTC, TC, BPU+++, Drag Radials
- AZ WOTM clutch question
- Help please,
- help! car keeps stalling
- HKS 50mm W.G.
- Two questions: VSV and EGR
- Wheel Fitment? Racing Hart C5 Specific
- +12v EFI main relay on harness plug EA2
- 6-speed DS install
- Good Fuel Pump Info
- please help...may be really important...
- Warm start cranking problem - will pay for answer
- Line Lock Pics please
- radiator shrouds - NA/TT - same?
- Garrett GT42 - Anyone know anything about it?
- Work Equips from MKiv
- Going big single help please!
- help...car feels weird when letting off throttle
- Low boost when secondary turbo kicks in...
- LED mode on FJO
- Loud Click
- ECU fuse kept blowing
- HKS 2835 Question: full boost at what rpm?
- 18mm bung for wideband
- Non-intercooled project underway
- Possible spark plug problem?
- What Nitrious Kit to buy...
- Weird Idleing.... no idea what it could be..
- Supra Coilpack connector plugs
- HKS adjustables?
- Removing Fuse under hood Need help
- GReddy Boost Gauge Disassembly?
- Veilside Manifold
- Misfiring on cylinders 4,5,6
- 6-speed BPU Tranny Issue - Please Read
- New Cams - Springs required?
- Alcohol Injection as a replacement for Higher Octane?
- Odd fuel delivery problem. Opinions wanted :)
- Greddy Turbo Timer E-brake function
- "MAX Air" Airbox dimensions
- greddy gauge needle problem
- Difference: T88 and T88H ?
- What makes this noise?
- Defi gauges - why can't the wires be extended??
- hks tripple wont disengage?
- Glassheadlights vs '98 headlights
- replacing cable...
- Planning To install T88H kit...
- Technical ? About Suspension
- ?s on NA/TT swap
- How does the blitz boost solenoid work - anyone know?
- car wont start
- Is it bad to have the car jacked up with the top off??
- 256 vs. 264 vs. 272 pros cons?
- How to install the shift rod seal? I searched
- NA-turbo swap... Sticky anyone?
- Rerounting boost ?
- Problem with second Turbo not kicking in..
- What cam lift can cause interference??
- Throttle Control Unit
- Single Conversion and Emissions.
- Ideal fuel pressure for T72 .81q?
- Tein Installation question. Help
- Auto to manual swap questions...
- Rear Suspension Linkage and Bushings...
- quick Q's bout Air/Fuel gauge
- Kyb Agx Settings
- No spark, where to start?
- built bottom end-recommendations?
- Resetting ECU
- Oil pump modifications
- High rev limit reliability?
- 27 psi bpu - Dangerous?
- Electrical Nightmare
- AVC-R problem
- interior light wont dim and the gauges wont come on HELP
- bad throwout bearing?
- changing turbine housings on singles
- stumble @ 5k, and a little more in the higher rpms..
- Car Wont Start??I Get Spark, And Fuel Pump is Pumping Fuel........Help Please!!
- Car Wont Start??I Get Spark, And Fuel Pump is Pumping Fuel........Help Please!!
- twin or na
- Code 25 - Lean A/F?
- left blinker faster than normal
- engine help... how much will it cost?
- Compressor housing size - affect on performance?
- Power FC, Has anyone??
- clicking noise when trying to start
- Has anyone w/ an OBD2 supra swap MAFs w/ an OBD1?
- Ignition problem
- IS300 Rear Breaks Supra NA Brakes?
- valve diameter
- maf, why can't one be used off of a car with better flow?
- ABS light
- Any easy/cheap way to lean out a bpu supra?
- Bad to have too much race fuel?
- 52Kmile MKIV Boiling Over!!??!?!?!?!?!?!?
- How to Resatart an old 2jzgte?
- Splicing boost gauge into boost controller?
- Indiglo Gauge install, NEED HELP IMMEDIATELY
- Turbo Pressure Malfunction (Code - 34) Suggestions?
- lots of white smoke
- Turbonetics Deltagate Wastegate !
- Torque specs for engine mount nuts...asap
- do supras have..?
- Not enough timing - Dangerous?
- Reversing the heater hoses?
- Do aftermarket pistons support OEM oil cooling?
- OBDI vs. OBDII
- exhaust housing damage - repairable?
- 98 Single Problems! Help Appriciated
- Stock pistons composition
- Speed sensor code
- How many miles to break in a motor before racing?
- Tire size Q's.
- How to change an electrical connector?
- voltage sent to ecu by the mass air MAF?
- cruise control not working
- flywheel bolts for the rps carbon carbon?
- difference in stock cats 94-98?
- Has Anyone Installed the Crower Stage 3 Cams?
- Plumbing external pump'd fuel system
- stock wheel widening?
- Gauge readings what is normal
- How long before bad flywheel causes problems?
- Ticking Sound at 1-2k rpm 1st gear...
- Sagging Springs Common
- reverse gear grinding?
- another check engine light question
- has anyone use the 295/35R19..?
- Differential worn out? How do I tell?
- A simple question about supra VIN number...
- help... no compression from cylinder 6
- hks triple clutch HELP!!!!!!!!!
- obd1 techtom on 98 obd1 car
- clutch problem
- VPC problems
- mkIV bpu's
- crower valve springs - rev limit??
- flame thrower exhaust
- Those who have had slave or master cylinders fail??
- Single Turbo Conversions in California
- Startup
- headlight question please help
- VPC and Air Idle Control Valve
- MOdifying the v160
- MAF Problem?
- Slave Cylinder
- valve length and stem diameter?
Powered by vBulletin™ Version 4.1.0 Copyright © 2013 vBulletin Solutions, Inc. All rights reserved.