Greddy 4 row intercooler question

[supra94t]

anyone running the Greddy 4 row with a single turbo installed? If so, did you have problems with the intercooler pipe lining up under the compressor housing of the turbo? supra94t@aol.com

[Philly Single]

Mine is off center...ever so slightly...not perfectly lined up, but darn close:

Notice where IC coupler is:
http://www.t72supra.com/motor.jpg

[supra94t]

thanks philly

[blkdawg]

what kind of turbo you running? mine lines up perfectly, but like Jay, T88H here. If you are having problem try reversing that pipe... the little arrow should be pointing up towards the turbo, it's kind of confusing cause on the rest of the pipes arrow points toward the core.

here is a closer shot

http://img108.exs.cx/my.php?loc=img108&image=4rowFMIC_install_23.jpg

[supra94t]

I reversed the pipe and came up with the same results. Don't laugh but, I am trying the Master Power T70 turbo

[blkdawg]

http://img103.exs.cx/img103/3416/kjhffkjf.jpg

[supra94t]

thanks blkdawg

[Bad4URHeart]

I had to purchase pipes from Boost Logic to get it to fit with my SP74 on the Greddy/BL header (same issue with an SP67Q). My PT60 did not require any modification.

[supra94t]

thanks "bad"

[Chucky Doll]

70mm turbo's compressor surge like a mother on a 3.0L motor. Hope you have the anti-compressor surge cover.

[supra94t]

not yet, maybe i need to look into that

[MACH1nTTcoupe]

that Greddy #1 pipe (4 row)is MARKED reversed from (factory) Greddy, have seen it twice before... unless they corrected their labeling $hit.

[supra94t]

thanks Mach1