WTB: MKIII RHD 7M Digital Dash Fuel Sending unit

[Supra Guy Scotty]

I am building a RHD MKIII here in the United States, and my digital dash clip is going to need the correct fuel sending unit to work. an anyone help out? Even if I can get the part number, that would be a start to seeing if I can still order it from this side. Any help would be MUCH appreciated!



Scotty

[clapyohandz]

ebay UK would be a good start, I'm sure you could find everything you need there.

[Supra Guy Scotty]

You'd be surprised. It's like finding a needle in a haystack. I am hoping someone will run up on one in a junkyard or something, because I need to body connector plug and some wire length on it too. I think the Digi Dash is a 4prong and the regular is a 3prong IIRC. It wouldn't bother me so much for my local commute, but I am HOPING to drive this car to Toronto this year for the Supra meet. Heck, if I could even get someone in Japan, Australia, or the likes to go to their Toyota dealer, and get me the part number for it, I can see if I can somehow special order it from here...



:-(


Scotty

[Philly#1 Lex]

Im here in Japan I will look for what you need and get back to you.

[Supra Guy Scotty]

Im here in Japan I will look for what you need and get back to you.


Thanks a bunch! I am sure it could come from a 1JZ car with a digital dash also, but I'll take what I can get. In fact, if there was a way to get your hands on an entire rear of the car harness, basically from the plugs that plug in on each side of the floor at your feet all the way back to the back of the car, and the plugable wiring from the radio area down to the console, I could use ALL of it. That way I know it is all plug an play, and no wires are in different holes in the plugs being my rear harness is still US stuff. Just an extra thought. Let me know what you find, and thanks again for your help!

best regards,

Scotty