fuck me i just bought the older version from you guys, shoot me a a price shipped to 01301
fuck me i just bought the older version from you guys, shoot me a a price shipped to 01301
94 TT 6speed BPU, under construction at Undercover Performance
97 TT 6speed stock sold
H.a ^^^me 2 fucccccccccccccck ...PRICE>>11516
Last edited by DSMTO15; 04-19-2012 at 09:11 AM.
*5*0*3*
PM's sent!!
Regards,
Robert
pm price shipped to 33025 please
1997 sc 300 NA-T black/custom tan int,AEM TUNED by Alpha 597@19 psi 93 octane
auto couture body kit , TT HG,t67 dbb .81 a/r,TTC 268 cams,Brian crower springs/retainers, boostlogic down pipe,boostlogic ceramic manifold,FFIM, Q45 TB,tial 44m,r154soarer,act stage 3 clutch, lsd 3.77 diff, tial 50mm blowoff,FIC 1100 cc inj,twin intank walbro ,FSM Fuel rail,HKS DLI,mishimoto rad,STANCE gr coilover,&swiss 20x9/20x11,rotora 6piston frnt 4piston rear 355mm
PM sent!
Regards,
Robert
Robert,
Please pm me a price shipped to Canada, Toronto L1T3A9
Thanks,
Ron
++BW S400SX3 67 FMW / GSC S1 Cams / HKS TI / RPS CC / Meth / GFORCE++
question..... reading from aem site , trying to confirm if you can configure display to have led show afr and the faceplate sweeping leds show boost pressure ..
fml, just bought the old unit -.-.... Pm for price as well, 33023
So purchase of this = laptop data logging of boost and afr without an aftermarket ECU? nice!
Price please to 37814!
PM's sent!
Regards,
Robert
Robert, can you pm me a price as well. Any word if they will work on a tru boost version that can do boost control plus the wideband and fail safe to reduce boost pressure automatically to prevent failure? That would be awesome.
1995 TRD Widebody - 56K miles
# One low-side driver output (Ground with 1.5 amp max draw)
I spoke with AEM and since you have a Tru-Boost the answer is YES. You would simply wire that low-side output to the switch on the Tru-Boost. For example if the alarm is activated on the Failsafe it would then turn the Tru-Boost off in turn going to wastegate pressure.
Regards,
Robert
Price shipped to 95825! Please!!
Welcome to my nightmare!
That is cool to know. What I really wanted to know is if they are working on a possible version of the gauge with the tru boost built into the fail safe gauge. I would love to only have 1 gauge in the car where the clock goes (Boost controller, Wideband and boost gauge all in one plus the protection factor). I am glad to know about the ability to connect it to my tru-boost though. Thanks.
Not that I'm aware of at this time sir.
Regards,
Robert
I'll reply for MVP on this one. Yes the gauge is configurable for the sweeping LEDS and the center OLED. It comes with different faceplates that denote the sweeping LEDS for boost, Vacuum(N/A), Lambda and AFR. So you can set it independently of the center OLED. Than the same for the center you can program so it will display boost, Vacuum, Lambda or AFR. So you can do Boost on the outside and AFR in the center or vise versa or have a complete AFR inside and out.
In lambda. It doesnt matter what fuel you are running.
PM me a quote for Victoria BC Canada V9B 4B1. Thank you.
PM sent!
Regards,
Robert
PM me a mod price to 21128. Thanks Robert.
1994 Alpine Silver 6spd
Full Race/Twins Turbo Built