Supra Forums banner

2jz gte vvti

  1. For Sale/Wanted - Parts, etc.
    FS: 2JZGTE VVT-i Wiring Specialties Engine Harness. Unused, new. Built for use with EV-1 Injectors ( not EV-14, they made a mistake in original order and took back the whole harness to change them over), IGN1A coils, AEM Infinity 6 Standalone, AEM sensor assembly (MAP/IAT/Boost Control...
  2. NE: For Sale/Wanted
    Looking to buy a 2JZGTE VVTI or NON VVTI Just stock engine
  3. MKIV (1993-1998)
    Looking at the manual for reinstalling the timing gear onto the crankshaft, it shows it sliding on easily. There seems to be no need for any tool or force, just line it up with the keyways and push it on. When I try to do this it only slides on half the width of the gear and I get resistance...
  4. MKIV (1993-1998)
    Hey guys I’m getting this intermittent noise when starting and running my motor. I have check oil pressure and oil no metal shavings or metallic in oil. I primed oil pump with 6 quart through the feed line, using a garden sprayer. I’m running bc264 cams. Here is a link to the video. Need help...
  5. 1JZ/2JZ Swap
    Hello Everyone, my name is Steven Hernandez. I am writing to hopefully get a little bit of advice. So I have a 99 Ford ranger prerunner and recently I swapped in a 2jz with single turbo. Problem I have now is the transmission as I'll be running an AEM V1 ECU. I am planning on swapping in a 4l80e...
  6. Supra FAQ
    Good afternoon everyone, I've recently bought an aristo 2jzgte vvti and I'm putting it in a jdm 95 Supra. I am purchasing extras I need to complete the set-up and I'm currently looking into exhaust components. I've noticed that some downpipes/midpipes that are listed for sale say they can't be...
  7. MKIV (1993-1998)
    I know replace the hose, already did that all the hoses for the heater have been replaced still got a small leak back there, ive noticed that the top heater neck has some play to it which I don’t remember it having before when the engine was out of the car. what should I do is there any...
  8. General Supra Forum
    Hello everyone. I’m currently running true twin conversion, with a 2.5” cat less down pipe to 3” straight, and a boost cut controller. Currently boosting 1.4 bar on usdm spec twins. Fuel system is stock currently and will be upgrading the pump when the funds come available. I’m wondering if the...
  9. MKIV Technical
    I recently bought a new O2 sensor for my 2JZ GTE VVT-i because I needed one that could screw into the bung on my downpipe rather than welding in the OEM one. When I got it I noticed they looked slightly different but they both have the same connector and 4 wire plug. After some research I...
  10. MKIV (1993-1998)
    I am looking around at cars online specifically MKIV supra sz models, how can i tell if one is vvti or not when buying?
Top