Supra Forums banner
1 - 1 of 1 Posts

· Cheifbootknocka
2,117 Posts
Discussion Starter · #1 ·
Anyone have valve shims I can use or buy ? Im shimming my new head and have the exhaust side done, but moving on to the intake only 2 of the 12 shims work. I pulled 24 shims out of my GE motor but none of them were thin enough.

Willing to trade or buy some. The 10 I need are entirely too tight so I cant even get measurements. I need some that are 2.70 or smaller.
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.