Supra Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
16 Posts
Discussion Starter #1
Hi,
I was taking the engine out of the clip and noticed a cut rubber hose. There is a small caliber rubber hose from the fuel rail to the intake. There is a 3 way elbow? with a cut hose. Where is this supposed to go?
 

·
Registered
Joined
·
16 Posts
Discussion Starter #2
2nd question

I have an auto soarer clip going into a 5spd SC 300. I noticed there is an extra small fan along the radiator. My SC 300 did not come with one. For those who have my same setup, is this fan necessary? Should i set it up to run when the engine runs? or do i not need it?

Another thing, there is a sensor on the bottom of the radiator. What is this for?

thanks for your input.
 

·
Resident Smartass
Joined
·
1,052 Posts
Check your FPR and make sure that the hose is connected, that may be it and your car will run like crap with out it hooked up...TRUST ME
 

·
kaizen Motorsports
Joined
·
1,402 Posts
Hey there,

The Fan is for AC and so is the switch/sensor on the bottom of the Radiator. As to the "T" , that could of been for a boost controller Vaccum T.
 
1 - 4 of 4 Posts
Top