Supra Forums banner
1 - 6 of 6 Posts

· 91TT comin up, 01 s2k
Joined
·
2,977 Posts
Discussion Starter · #1 ·
Ok doing a 2jz swap, came to notice there's a few extra plugs. Do I need them, pick are below. Two plugs on top of engine and 4 plugs were the ignitor is. It's a 94TT harness. Please help trying to get it done before Vegas.


 

· Registered
Joined
·
1,054 Posts
gray one in the last picture is a noise filter for ignition
 

· Not so boring anymore
Joined
·
7,936 Posts
1st pic - EA1 & EA2 connector
2nd pic - VSS and Reverse lights off trans I think (not a good indication of where the wires are coming from)
3rd pic - Noise filter, resistor pack connector
 

· 91TT comin up, 01 s2k
Joined
·
2,977 Posts
Discussion Starter · #6 ·
ok thansk, I'm using the r154. And another thinf your earlier statement stated that where the pulgs us coming from don't look to good. Can you explain that a little more, where should it go?




umm.. yeah.. except the vss, the speedo gives you that on a mkiii (unless youre using a mkiv trans).
 
1 - 6 of 6 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top