87 7mge Supra selling everything | Supra Forums

1 - 1 of 1 Posts

B

BmXRacR96

·

Guest

Joined Jan 1, 1970

·

0 Posts

Discussion Starter • #1 • Dec 24, 2001

The entire car is for sale or will part out. have no title.

everything is good only 50k on motor.
manual trans 5 spd
the motor is torn down. was doing a complete overhaul but came accross financial problems so i need the money

motor and manual trans is out of car. just email me what u need and a resonable price and i will get back to you

thx doug

1 - 1 of 1 Posts

Recommended Reading

Waste-gate stuck open?

Naturally Aspirated

I'm pretty sure this is a no brainier, but I had my car running up in the air on a lift after doing some repairs and inspecting. I noticed that the dump tube off of my waste-gate is puffing. Am I right to assume that the waste gate should not let anything past until it's spring pressure is...
- 4
- 71
- TrueGS300 · updated 8 h ago
IS300 Coil Pack brackets for NA Supra?

Naturally Aspirated

Hi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)
- 4
- 273
- W
  WarIsHate · updated 1 d ago
NA-T high increasing idle after IS300 coil pack conversion AEM v1

Naturally Aspirated

Hi Supraforum'ers, Has anyone experienced a high idle 2500 rpm + (that keeps increasing) after you converted from distributor to the IS300 coil packs with AEM EMS v1 (or similar engine management system)? I set the base ignition timing with AEMPower's wizard, and made sure the throttle body...
- 7
- 332
- W
  WarIsHate · updated 2 d ago
Fuel pressure

Naturally Aspirated

I just got my return fuel system finished up and am having an issue with setting fuel pressure. I ran a Walbro 525 pump with an 8an feed and 6 an return. FuelLab regulator on the return, with a Radium Engineering gauge. All parts high quality. I can't get the gauge to read past 20psi. The car...
- 6
- 157
- TrueGS300 · updated 2 d ago
TPS calibration

Naturally Aspirated

Okay, so I have read the tsrm for the calibration method and was wondering how exactly to apply that to an aftermarket ffim with an RMR 90mm throttle body. Am I even using the right TPS sensor? I have the factory 2jzge (cali spec) TPS sensor on the car. The issue I'm having is uncontrollable...
- 14
- 781
- M
  merlin33bc · updated 4 d ago