Supra Forums banner
1 - 1 of 1 Posts

· Low 9 sec SC300
Joined
·
442 Posts
Discussion Starter · #1 ·
i put an aem ems in my car, 2jzgte single and i am wanting to add the iat sensor but have been reading up and it says to just replace the one on the USDM gte and on the jdm ones there isnt an IAT sensor. So where would it go? if i use the same pin (b45) then that would mess up my map sensor signal. any help would be greatly appreciated
thanks
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top