Supra Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
684 Posts
Discussion Starter #1
What's going on guys? It's been a while since I've posted, but I'm always around. This is my current set-up:

Re-built motor with 3k miles
-Re-balanced crank
-Crower Rods
-.40 JE Pistons/ Rings
-Titanium Valve Springs & Retainers
-2.0mm HKS Stopper HG
-Stainless Steel Valves
-Level 5 Frankenstein Greddy TD06-20g (Garrett E60 Compressor Wheel/Flows 750 CFM) on ebay manifold
-Port & Polished Intake manifold
-Maft-Pro
-Ported Throttle Body (64.6mm, Duane's old set-up)
-680cc Injectors, Walpro etc......

So, in short, in order to mount my 20g on the ebay manifold, I needed an adpater and a custom V-Band Elbow (Produced by [email protected]). However, the T3 V-Band 2.5"-3" adapter I purchased from ATP doesn't match up with the 20g . The spacing on the holes are correct, however, they do extend outward enough. Now, I'm stuck. I was in contact with them and they said they would made me a custom piece, however, the emails stopped, and goodluck trying to contact them over the phone. Sorry for the long post, but where do I go from here? Once I get this straightened out, all I have to do is hook up my electronics and fab up some IC pipes with the help of Bryan (Slow66). Any advice is greatly appreciated.

Mo


Edit: I tried posting the pics, but even when I resize them, it says I'm exceeding the forum quota?? I also had a picture of a T3 Internal Wastegate ATP offers on their website. Thats the exactly what I needed my adapter to be, but I guess it didn't work out.....
 

·
20G Boostin'
Joined
·
1,676 Posts
find another machine shop and have them make something custom. i had to get a custom elbow made made for my 20G..

 

·
Registered
Joined
·
182 Posts
Not to hijack but can someone post some pics of the 20G in the engine bay?
 

·
Registered
Joined
·
684 Posts
Discussion Starter #4
Well, I could, but the piece that already had made is very nice. It's a 3" V-Band elbow and has an EGT & Wideband bung welded on. The problem is, I purchased a 2.5"-3" V-Band Adapter module for my T3 from ATP, but it didn't match up. What you have pictured is exactly the flange, I need but thats not what I received.

This is what I bought:
http://www.atpturbo.com/Merchant2/m...tp&Product_Code=ATP-FLS-030&Category_Code=BCS

Mo
 
1 - 4 of 4 Posts
Top