Supra Forums banner

Aftermarket head gaskets? Help please.

580 Views 8 Replies 3 Participants Last post by  tkr*sc300
I need a thicker (3mm) head gasket for my 2JZ-GE that I am turbocharging. Does anyone know of any shops that can make headgaskets to spec or that would likely stock a thicker gasket for my car?

I was going to buy the Fmax headgasket, but it was $250 and the distributor said there was someone who advertised in the back of Turbo mag that can "make any headgasket, for any car, to any compression ratio"

Help is much appreciated.
1 - 9 of 9 Posts
http://www.headgasket.com/

try them they might have what your looking for !
Can you give me the info on who makes any gasket you need? Also how many mm is the stock headgasket in the n/a supra 93-98 .

Also any one know where the turning signal fuse is or where the box is that control it cause i took my dash apart to change my radio put it back in and now my blinkers/ dont work Thanks

Xdreamer
Xdreamer said:

Also any one know where the turning signal fuse is or where the box is that control it cause i took my dash apart to change my radio put it back in and now my blinkers/ dont work Thanks

Xdreamer
look under the driver side dash near the firewall or under the hood near the battery!
i checked the fuses under the hood there all good. Wheres the other fuse box? Thanks
RanGer498 said:


under the driver side dash near the firewall
your feet ;)
G
RanGer498 said:
http://www.headgasket.com/

try them they might have what your looking for !
good copper head gaskets.

I'm probably going to get my Z's gaskets from here when the time comes.
Xdreamer said:

Also any one know where the turning signal fuse is or where the box is that control it cause i took my dash apart to change my radio put it back in and now my blinkers/ dont work Thanks

Xdreamer


THREAD-JACKING!!!!!!
G
i got mine from powerhouse... try either powerhouse or toyomoto

-brian
'92 turbo veilside rsp sc300
1 - 9 of 9 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top