Supra Forums banner
1 - 5 of 5 Posts
G

·
Discussion Starter · #1 ·
Okay.. my guages were removed and now the air bag light is on

Yes, yes I have read the install and how to make this go away, but I wonder something

it says to put a "harness" into AB and TC (or something) and then alternate that connect with the negitive pole on the tbatter

is that correct or is there more to it???

Thanks alot guys!
 
G

·
Discussion Starter · #3 ·
ohh okay.. once more.. I run a long wire from the diag box to the neg terminal and do this procedure.. correct?
 

·
Registered
Joined
·
2,122 Posts
You can use any ground. I usually use one of the studs coming up through the body at the shock tower. You need to ground in the following sequence: TC, AB, TC, AB then hold TC to ground until cleared. Sequence needs to be done in 1 sec holds with no more than .2 sec when switching between TC and AB.
 
1 - 5 of 5 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top