[QK94DAWG]

Hey Guys, does anyone have a DEI login still? I don't have one anymore and I need a printout for a 2007 Rav4 for remote start/alarm.


Thanks in advance!!! :bigok:

 

[sincal2jz]

choose one..........

http://directechs.com/DirectWire/DirectWire.aspx#

http://directechs.com/DirectWire/PrintVehicleSmall.aspx?VehicleID=10501&Section=AllProducts

 

[QK94DAWG]

choose one..........

http://directechs.com/DirectWire/DirectWire.aspx#

http://directechs.com/DirectWire/PrintVehicleSmall.aspx?VehicleID=10501&Section=AllProducts

I need a DEI login for either one...

Care to share? PM me if you'd like.

 

[sincal2jz]

CLICK THIS LINK :
http://techservices.audiovox.com/

AND THEN CLICK ON "THIS LINK" TO REGISTER FOR FREE AND IT WILL GIVE YOU ALL ACCESS TO ANY VEHICLE..........

IN MY OPINION........AUDIOVOX GIVES YOU BETTER AND MORE INFO THEN DIRECTECHS....

 

[QK94DAWG]

CLICK THIS LINK :
http://techservices.audiovox.com/

AND THEN CLICK ON "THIS LINK" TO REGISTER FOR FREE AND IT WILL GIVE YOU ALL ACCESS TO ANY VEHICLE..........

IN MY OPINION........AUDIOVOX GIVES YOU BETTER AND MORE INFO THEN DIRECTECHS....

Thanks! I did end up finding a connection for a directechs password...and I use the bulldog security site too....but ty for the heads up on audiovox!

 

[TonyN]

ralph,

can you get teh info for the supra so i can check mine?

 

[Supradedupra]

I've been working on installing an alarm in my car all day. Here is the wiring information I've found:

http://www.the12volt.com/installbay/alarmdetail/2130.html
http://www.supraforums.com/forum/showthread.php?t=363057
http://i136.photobucket.com/albums/q192/liewsaephan/s-diag.jpg
http://i136.photobucket.com/albums/q192/liewsaephan/s-diag2.jpg

I hope that helps. I'm still not done... lol.

Edit: I did all my major wiring on the brain, and everything works great! Here is my basic wiring solutions:

12v and 12v switched - the clock
Ground - bolt behind the dash
Power Locks - Green and Yellow and White wire on the passenger kick panel on the blue harness. I accidentally wired these backwards, but that was a quick fix (i.e.- it was locking when it was supposed to unlock)

For the parking lights flash, I used the very bottom white harness, and it was the Green wire on the drivers Kick Panel (1C16 on the diagram below)

For the Door trigger, I used the harness right above it with the red/white wire (1E9 on the diagram below) on the drivers kick panel.

Here is the drivers kick panel diagram:
http://mkiv.com/manual/1995_electrical_manual/F/95elec_020.JPG

Here is the diagram for the parking lights (so you can double check where 1C16 is going):
http://mkiv.com/manual/1995_electrical_manual/I/95elec_102.JPG

Here is the wiring for the door trigger (so you can double check IE9 to see where its going):
http://mkiv.com/manual/1995_electrical_manual/I/95elec_118.JPG

If anyone who has done this before finds fault in this, please let me know. Everything seems to be working as far as the brain goes right now, but I could always use a second eye