Supra Forums banner

1 - 2 of 2 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter #1
I got a 1jzgte custom aluminum intake that I was going to put on a 1jz but the deal with the motor did not come through. I got a good deal on a redone 7mgte and picked it up. I still would like to use the manifold but I need the runner on it cut off and 7mgte lower runners welded on. the runners don't line up just right so you may have to cut off the bottom plate and make a new one with the 7mgte runners on it. but ever place I call says they don't do stuff like that.
 

·
DFWSupras
Joined
·
1,627 Posts
Assuming you are near Dallas... call Don Scott's Rod's in Garland tx 972 926 7637. He welded a wastegate flange on a cast iron manifold for me and has done some aluminum work for me.
 
1 - 2 of 2 Posts
Top