Supra Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
459 Posts
Discussion Starter #1
Just put the plates on. Am i safe to assume that since i didnt get a CEL after a twenty minute drive that I installed the resistor correctly? Also its hard for any one to tell if a bolt is tight enough at an angle like that, so if i dont feel air coming out then im good? And another question, lets say the block plate was not on tight enough and it was leaking, what could this do to the engine? I know these questions are a little gay and whiney but i feel like these things could be touched apon with a little more detail. Thanks guys
 

·
Mamba Still On Top
Joined
·
3,462 Posts
Drive it a 2 times after resetting the ECU and you'll know. Mine always came on the 2nd drive.
 

·
Registered
Joined
·
459 Posts
Discussion Starter #4
sweet, Ill give it a try and see what happens
 
1 - 4 of 4 Posts
Top