Supra Forums banner
1 - 1 of 1 Posts

· Registered
408 Posts
Which wideband is this?
There should be a setup for either logging or viewing of the different inputs.
If you set your minimum to .64V and maximum to 3.90V, you should get accurate readings.
The SAFC was actually pretty accurate after being set-up.
Most people don't know about setting up the SAFC throttle.
You go to the screen where you set the TPS sensor type (it has an arrow either pointing up and right, or down and right)
You select up and right and then press all the way down on the accelerator and hold for a few seconds.

Good luck.

1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.