Supra Forums banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1,691 Posts
Discussion Starter · #1 ·
when i went single and did my wiring for my MAP sensor and IAT, my wires were not the correct colors...in fact they were the colors for a N/A supra...i ran the VIN and it was correct...97 TT 6 speed...but why were my wires the wrong colors? Im talking about the wires in the MAF you use for the IAT
 

·
Registered
Joined
·
1,691 Posts
Discussion Starter · #5 ·
no no, i think you are misunderstanding, i eliminated the MAF and changed over to MAP, but i spliced into the wires to run leads for the IAT sensor i installed in my manifold....harness is untouched, just that when i was splicing, the wires didnt match what the TIS site said the colors should be for a 97 TT 6 speed
 

·
Registered
Joined
·
1,691 Posts
Discussion Starter · #6 ·
supratt320 said:
The GTE maf has different colors between the 93-96 and 97-98.
Check this link out: http://www.moreboost.org/dual_maf.htm

thanks for the link, yeah i have a green wire with black tracer, the wiring diagram says it should be pink, so im ok.....well everything workes fine anyways, i just wondered if anyone else ran into this
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top