Supra Forums banner

Apexi Rev/Speed Meter help

515 Views 2 Replies 2 Participants Last post by  SyCK
Anyone running this unit? I was hooking mine up and on the documentation it states that SP2+ and SP2- go to 2 specific wires at the harness as usual. But, there are no wires at the 2 pins they call for, the pins are plugged and not in use from the factory. Apexi's site has no contact info so I can't mail them about it so.. has anyone dealt with this before? I'm sure I can use it without these 2 as I am sure they are just some monitoring wires, but what do they monitor? SP2+ & SP2- ?
1 - 3 of 3 Posts
Euphoric,


I have the rev/speed meter. The hook ups are the speed-o wires for the ecu. The ECU has 2 wires. You just need to hook up to one for the meter. SPI is apexi east coast distributor. give them a call.They should be able to help you.

spi phone number-(718)-894-5105


good luck!!

-TY
See less See more
TYWRAP said:
Euphoric,


I have the rev/speed meter. The hook ups are the speed-o wires for the ecu. The ECU has 2 wires. You just need to hook up to one for the meter. SPI is apexi east coast distributor. give them a call.They should be able to help you.

spi phone number-(718)-894-5105


good luck!!

-TY
Thanks, are you sure they are Speed-O wires? Cause there is already a different wire hooked up for Vehicle Speed Signal. What pins do you have yours tapped into cause like I said, the ones the manual calls for are bunk pins.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top