Supra Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
298 Posts
ARP studs

You seem to have the sequence right. Hand tighten the studs into the motor, drop the HG on, and carefully install the head. Put all the nuts on, and work from the center out in an x pattern, torquing them to 65ft/lbs. Wait a few hours and torque them again. The moly lube was included in the box with my ARP's. Lube both ends.. If anything is unclear, give Larry at SP a call or e-mail. He'll know, thats where i got my info..
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top