Attention Thermactor | Supra Forums

1 - 1 of 1 Posts

BlackSupra93

·

Now...Whitesupra94

Joined Nov 25, 2001

·

3,273 Posts

Discussion Starter • #1 • Mar 4, 2002

hey dude, i was just wondering, was it you that had that post with the garfield comic stip. could you post your website? i was looking at the garfield comic strip and it cracked me up so much. anyhow, my friends have a "special understanding" that is described quite well in that stip and i'd like to show it to them. It was you that posted it right?
thanx
Bob

1 - 1 of 1 Posts

Recommended Reading

Best EGT sensor (rtd type) location for NA-T?

Naturally Aspirated

Hi guys (and gals), Where have you folks installed your single egt sensor and how well did it work? I have a 2JZ-GE na-t car (non-vvti) and am curious where is the best place to weld in my AEM egt sensor (rtd type) bung. [easy access vs accurate readings... closer to an exhaust valve is more...
- 1
- 29
- W
  WarIsHate · updated 8 h ago
2JZ-GE NA Running 14:1+ Compression

Naturally Aspirated

We are building SC300 with a 2JZ-GE NA for a Bonneville Land Speed record attempt. We're working through all the engine mods including a lot of head work. Based on the regulations we will need to run VP Racing Fuel C14. Possibly C14+ but it's unclear if that will pass tech. Does anyone have...
- 9
- 356
- N
  nick430 · updated 4 d ago
IP Hexa Pac Ignition coils

Naturally Aspirated

So I am considering doing the COP conversion and not messing with the dizzy at all during an NA-T install. I just so happened to stumble upon these and couldn't find any info or anyone that had used them in the search...
- 1
- 92
- TougeSC3 · updated 6 d ago
IS300 Coil Pack brackets for NA Supra?

Naturally Aspirated

Hi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)
- 3
- 174
- W
  WarIsHate · updated 6 d ago
Fluidampr Crank Pulley = -2 degrees mark?

Naturally Aspirated

Hi guys (and gals?), I’m in the process of upgrading my timing belt and crank pulley. When I aligned the bolt hole notches and overlaid my new Flyuidampr crank pully over the oem 2JZ-GE (non-vvti) one, the Fluidampr’s timing mark was at -2 degrees inline with the oem crank pulley’s white...
- 4
- 157
- W
  WarIsHate · updated 8 d ago