Auto To 6spd Swap
Join the discussion
Recommended Reading
-
Boost cut controller.. why no worky
MKIV TechnicalAre you guys using a sensor ground for your bcc or chassis ground? I don't want to cut my harness so came up with this rough contraption. Something so simple yet 14-15 lbs boosts cuts every time. I started at 4.30v, kept turning it down after pulls to see if that was the case and nope still...- 1
- 46
-
Help with Cams and shimless buckets 2JZ-GTE
MKIV TechnicalWill be installing 272 BC cams, springs, retainers, keepers and of course those pesky oem seals. Still a bit confused on when I need to put motor at TDC since I am doing the "rope trick" does this matter? So would you do shimless buckets like this? Please correct if wrong. 1.Remove the...- 1
- 67
-
rallly · updated
-
Head gasket
MKIV TechnicalDoes this gasket look blown? enough to actually loose compression to zero?- 2
- 170
-
Kennygee · updated
-
Odometer problems need help!
MKIV TechnicalSo my odometer stopped working and i have resoldered it 2 times and everytime, it starts counting for about 5km and then stopps again. I have done the splice mod on the connector on the back also have tried putting it back to original and also tried removing my speedo converter but it didnt...- 2
- 153
-
Marcus.supra · updated
-
2JZ-GTE Igniter - Required when you go to a aftermarket harness + ECU
MKIV TechnicalI came across asking myself today, do you need a igniter when you go to a aftermarket ECU and Harness? I noticed my friend is running a MOTEC and does not have one for his car.- 1
- 144
Join now to ask and comment!