Supra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
200 Posts
Discussion Starter · #1 ·
I am about to start to install the B&M ignition on my car and have one question, which is the wire that I need to cut and tap into. This is the power wire that goes to the coils. Install seems extremely easy except that I don't know which wire to cut. Should I just follow the wires underneath the cover, or can I access this wire without taking the cover off? Any help would be greatly appreciated.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top