Best 315/35/ZR rear tire.
1 - 6 of 6 Posts
J
jkbrauch
·Guest
Joined
·
0 Posts
I'm using a 315/35-17 rear tire on an 11.5 wide wheel for the track. I have cut the fender lip and have coilovers, no rubbing problems. A 315/35-18 would be too big in diameter for the Supra.
Jeff
Jeff
Joined
·
353 Posts
Not on an 18"x11" wheel with the perfect offset... AMHIK...jkbrauch said:
-m
I'm sure that you didn't catch what he was saying. I'm sure you probably mean 315/30-18 in your AMHIK. 
Joined
·
980 Posts
Ok, what's AMHIK?
1 - 6 of 6 Posts
Join the discussion
Recommended Reading
-
E85 - What E85 compatible oil should I switch too?
MKIV TechnicalHey guys, I use my Supra on the road course, and I've been using MOTUL 300V 10w40 in my 2JZGTE on pump 94Octane with great results. I will be switching to E85 as soon as I am finished my single turbo/fuel system swap. - What oils are compatible with E85? Thanks Jay- 4
- 65
-
rallly · updated
-
Banjo bolt on fuel pump won't budge - ok to use impact wrench?
MKIV TechnicalGreetings, I'm having trouble removing the banjo bolt on the fuel pump assembly. Tried everything I could think of besides an impact wrench. Wanted to ask some folks if that was a good idea or not? I'd really appreciate any insight you can offer. To be clear and avoid miscommunication I found...- 11
- 184
-
Steering box
MKIV TechnicalHe, I have an issue with my supra mk4, The steering doesn’t response in same time, i mean when i turn right or left I don’t get response immediately. I have to take half turn then the car will turn. What can i do instead of buying a new steering box!- 0
- 19
-
a7med_mk4 · updated
-
Rusted crankshaft/gear/pulley - cleaning?
MKIV TechnicalHey guys, I removed my broken harmonic balancer, which was really a bitch to get off. I noticed some small rust and other rough patches on the crankshaft (especially around the key) where the balancer sat. The timing gear is even worse. Ruined my pulling tool half way, so I now first have to...- 0
- 44
-
Problems with AFR'S after single turboing 2jz GTE VVTI
MKIV TechnicalFinished single turboing my Aristo a week ago. I'm using my AEM UEGO as a narrowband sim to feed AFR'S to the ECU. My old sensor worked fine for like half an hour and then it died on me. Would show three lines (full lean). Got a new sensor and put it in today. Reset the ECU again for it to...- 0
- 83
Join now to ask and comment!