Best Pump Gas #'s

1 - 1 of 1 Posts

MaxPrime

Guest

Joined Jan 1, 1970

0 Posts

Discussion Starter • #1 • Feb 26, 2002

My goal in my single is to make the best #'s on pump gas and still have a decent spool time, what turbo is best for this? I've seen big numbers on the HKS Twins, T88 + T66 but they all seem to peak out around 600 RWHP. Any ideas?

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

Boost cut controller.. why no worky

MKIV Technical

Are you guys using a sensor ground for your bcc or chassis ground? I don't want to cut my harness so came up with this rough contraption. Something so simple yet 14-15 lbs boosts cuts every time. I started at 4.30v, kept turning it down after pulls to see if that was the case and nope still...
- 1
- 28
- C
  crazy3rdgen · updated 2 hours ago
Help with Cams and shimless buckets 2JZ-GTE

MKIV Technical

Will be installing 272 BC cams, springs, retainers, keepers and of course those pesky oem seals. Still a bit confused on when I need to put motor at TDC since I am doing the "rope trick" does this matter? So would you do shimless buckets like this? Please correct if wrong. 1.Remove the...
- 1
- 55
- rallly · updated 8 hours ago
Head gasket

MKIV Technical

Does this gasket look blown? enough to actually loose compression to zero?
- 2
- 164
- Kennygee · updated 19 hours ago
Odometer problems need help!

MKIV Technical

So my odometer stopped working and i have resoldered it 2 times and everytime, it starts counting for about 5km and then stopps again. I have done the splice mod on the connector on the back also have tried putting it back to original and also tried removing my speedo converter but it didnt...
- 2
- 150
- Marcus.supra · updated 1 day ago
2JZ-GTE Igniter - Required when you go to a aftermarket harness + ECU

MKIV Technical

I came across asking myself today, do you need a igniter when you go to a aftermarket ECU and Harness? I noticed my friend is running a MOTEC and does not have one for his car.
- 1
- 144
- P
  PushLimits · updated 2 days ago