Hi so my blinkers have been out on my 94 mkIV turbo for years.... hazards work and left blinker works but if I click the right blinker the flasher makes a horrible noise and it doesn’t work..
84329-14030 looks like the part number to the blinker switch but it’s dicontinued..
Not sure if I should buy a celica or corolla headlight multifunction switch and try to sway the part over and hope it works? 😐
Are you getting a bZZZZZZZZZZZZZZZZZZZZZZ sound? If so, its either a bulb or the wiring to the turn signal has a flaky connection.
I'm working through the same issue with my MK3. The wire that goes from the tail light to the side rear marker light is sensitive. Literally with the blinker on, if I move it just a bit it goes from click click to bzzzzzzzzzzzzzz and back to click click.
well I checked the harness, looks fine...
I also took out the switch, the switch is also fine..... I actually don’t have front blinker sockets.. took out the pods and sockets, I wonder if I should buy a socket just to see if it acts any different
I had been checking the front harness.. took out the right rear taillight and the harness had oil all over the wires and there are 2 wiretaps not sure why they are there... hopefully that is the issue...
part of the problem is previous owner put all kind of city lights and strobe lights all over the car... I took it all out after I bought it, but all his hacking at the harness worries me
I just recently did the front turn signal delete mod and wanted to share my process, shortfalls, and experience for those that may be interested. There isn't a very good diy or how-to guide on here yet, so I figured why not. This was performed on my 1995 JDM RZ. Your US model may have...
Before the Forum went down for a while, there was a thread on removing your front turn signals. I decided that the car would look better and there would be a possible performance gain by doing this. I recently installed a tranny cooler in the drivers side vent and the stock smic needs all of...
Got my blinker working.. previous owner put leds in the rear turn signals... they were both still lightening up for hazards and left worked correctly so I didn’t think the bulbs were the culprit..
But I took out the led bulb and resistor and put a normal bulb and all is working like it should now....
Thanks for the help @Dumeinao !!