Supra Forums banner
1 - 11 of 11 Posts
G

·
Discussion Starter · #1 ·
Does Nur spec (rear section) bolt up to the RMM downpipe or do I need to get the full cat back? I read somewhere that the full system replaces the cats. If anyone has this exhaust I would like to hear some comments?

Thanx,
Anthony
 

·
Registered
Joined
·
200 Posts
I never did measure the clearance on mine, but since installing it last May I have not scrapped it on anything. (Stock springs) I'm now installing Eibach springs so the car will sit a little lower. Also, I don't know anything about the Apexi N1, so I can't comment on clearance differences.
 
G

·
Discussion Starter · #8 ·
Re: clearance

95jza80tt said:
do you guys no how much the clearance is on that exhaust.. i have a apexi n1 right now and when i scrape on driveways i only scrape my exhaust pipes.. so i was thinking maybe changing to a rear section nurspec if that'll make any difference..

Brian

The N1 hangs much lower.
 
G

·
Discussion Starter · #10 ·
95jza80tt said:
piping and all or just the muffler alone?

The muffler hangs lower for sure and I think the piping does also
because the piping diameter is larger than NUR spec.
 
1 - 11 of 11 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top