Supra Forums banner
1 - 1 of 1 Posts

·
Registered
Joined
·
461 Posts
Discussion Starter · #1 ·
First off Im not sure where it was replaced before i got it but the top stud was not bolted. The bottom one came loose and when i pushed in the clutch it started making a clunking noise. About a mile from my house the clutch just went stright to the floor and the bottom stud snaped. I got it out of the master so all i need is a new stud. Looking at the top stud. Any advice on how to get to it to put the nut on it?? I cant get to it and that is probly why it was never done.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top