Supra Forums banner
1 - 2 of 2 Posts

·
Registered
Joined
·
502 Posts
Discussion Starter · #1 ·
I think the problem with my car lies in the cam sensors or the crank sensor but seeing as these sensors are $72 a peice is there a way to check my sensors to see if they are bad?we checked the wires from the sensors to the ecu and they were good and had continuity but how do i check the sensors themselves? thanks
 

·
Registered
Joined
·
502 Posts
Discussion Starter · #3 ·
Ok well i checked the resistance and it was as follows:

Cam sensor 1--- 1.146ohms
Cam sensor 2--- 1.131ohms

Crank sensor---- 1.156ohms

are these numbers too low do any of them seem to be bad and i would think since my car has been running fine for a year that i would not have the polarity wrong now......
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top