[moua4c]

Ok, since my last clutch install and damage, I just want to reconfirm that this is the correct setting..

for the flywheel to the crankshaft it's 36lb.
for the clutch presure plate to the flywheel it's 14lb.

Please someone confirm this.

 

[mkivsoopra]

looks like 36lb-ft then turn an additional 90°? :scratch:

 

[moua4c]

If it was that, it would include the 90 on the bottom .. you'd think.

 

[mkivsoopra]

If it was that, it would include the 90 on the bottom .. you'd think.

bottom?

 

[moua4c]

yeah, it should have turn 90 at the bottom under 36lb..if it required another 90 turn.

 

[mkivsoopra]

yeah, it should have turn 90 at the bottom under 36lb..if it required another 90 turn.

I think they're just being lazy. I highly doubt that they're asking you to turn an extra 90° only if you're reading the metric units on the torque wrench, but to stop at 36 lb-ft if you're reading standard on the other side. (36 lb-ft = 49 Nm)

 

[moua4c]

I see.. thanks for the clear up.