[VeilsideTT]

Sorry for all the questions regarding my syncing problem but I finally found out what is wrong for sure. I was just wondering if the CPS wires are exposed anywhere after they meet up with the harness right near the cam gears/front of valve covers. I ask because the sensor is good but I don't have a complete circuit at the ECU. I figure a wire got pinched somewhere but its tough to tell where these wires are going. Anyway, I did a fuel system and cams install so that could help in trying to figure out where a wire was pinched. Are the wires exposed anywhere near these areas?

 

[Curt Aigner]

No, only exposed at the CPS and then they go into the loom.

 

[VeilsideTT]

Hmm, now I'm really stumped. I wonder if this has anything to do with my bad ground. Do you know where pin 69B is supposed to get its ground from?

 

[Curt Aigner]

e-mail address please.......

 

[VeilsideTT]

[email protected] Sorry for cluttering your forum.

 

[Curt Aigner]

e-mail sent