Where could I find the two downpipe gaskets for a RMM DP. Will the ones sold by MVP for the Tanabe DP fit on the RMM? I went to the local autoshops, but all the gaskets there were too small. It was pretty funny to see me go to 4 or 5 different stores carrying my dp to try and much up the gaskets to the pip.
Downpipe Gaskets
Join the discussion
Recommended Reading
-
Odometer problems need help!
MKIV TechnicalSo my odometer stopped working and i have resoldered it 2 times and everytime, it starts counting for about 5km and then stopps again. I have done the splice mod on the connector on the back also have tried putting it back to original and also tried removing my speedo converter but it didnt...- 1
- 108
-
Marcus.supra · updated
-
Performance shops in VA/MD
MKIV TechnicalCan someone help me out I’m looking for a good shop near Newport News area or Baltimore area that specializes in supras. I’m will to travel an hour and half away tops in both areas. During the week I’m in VA and weekend MD. I just want a look over make sure there’s no major issues that I...- 6
- 96
-
Fuel door on widebody supras
MKIV TechnicalFor people with widebody supras, did you connect the cable release for the fuel door? Or did you leave it disconnected and just pull it open with your hand? Mine was left disconnected and I was wondering how the cable can be modified to work with the new bodykit. Thanks- 2
- 191
-
Servo Sub Assembly on AC
MKIV TechnicalI am having trouble with my AC and everything indicates I need a new servo sub assembly (Toyota Part # 87106-14120). Unfortunately this part has been discontinued. In my search for a new sub assembly (87106-14120) I have noticed a bunch of different Toyota sub assemblies starting with 87106...- 1
- 259
-
High rpm breaking up 97 supra 6psi
MKIV TechnicalWell I’ve been reading all this post about ignition breakup at 15 -20psi and spent a good amount of hours reading and then trying things here and there. Well this is my problem it’s a 97 supra gte/w58 with an aem v2 with an sxe 366 ONLY doing 6 psi(STILL ON A W58). It will be fine in 2nd gear go...- 17
- 430
Join now to ask and comment!