[integra777]

If I remove the drive shaft in half and did not mark anything on the spline, how do I go about putting it back to where it was before? Is there any factory marks? Thanks

 

[OWN3DU]

no it will go in when splines line up and then you turn it to get back to line up and that is it. no special marks

 

[integra777]

Well I cant just put in any angle position. It will throw the shaft out of balance. From what Ive gathered, the entire drive shaft is balanced with the rubber piece as well.

 

[runs11's]

I just changed my ds....didn't mark anything and I have no problems...1st thing I did was some highway pulls!!!