has any one ever tried one of these kits.. and is it worth it? http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=10428&item=4536250900&rd=1
ebay headgasket kit
1 - 7 of 7 Posts
Joined
·
378 Posts
althought i dont think it was the same kit, i ordered a gasket kit off ebay and it was pretty decent... No complaints here
Joined
·
378 Posts
Valve Stem Seals... I BelieveSpoolme said:
Joined
·
2,293 Posts
I got one on Ebay for my N/A no complaints had all the gaskets. Didn't have any leaks either.
Joined
·
2,023 Posts
everything should be ok except the head gasket. I wouldn't use their head gasket. Use a toyota. I bought a ebay apex kit 2 years ago and blew the head gasket. I think the head gasket is to blame. It's built to take stock tourque ratings. I went over that.
Joined
·
1,317 Posts
thats a great deal. i just bought mine from toyota yesterday for 350
1 - 7 of 7 Posts
Join the discussion
Recommended Reading
-
Body connectors for 88 supra 1jz swap
MKIII (1986.5-1992)I am dropping in a 1jz into my 88 supra, the only problem is the wiring to the body harness. I bought a shell so I don't have a 7M engine harness. Does anybody have an alternative other than hardwiring it in? I would hate to have to drop 300 dollars for a harness just to cut off the body plugs...- 2
- 52
-
turbo88 · updated
-
89+ head specific Quetion
MKIII (1986.5-1992)I finally decided to take my engine apart and replace the stock head gasket with a MHG I personally didn’t have a fail on the head gasket, not sure how many times the previous owner did. I’m the second owner While I’m at it I’m replacing the 30-year-old valve springs, just had to head...- 0
- 39
-
1jzge oil filter housing
MKIII (1986.5-1992)Hey I have an oil leak coming from my oil filter housing, I have the new seal to replace it, what I want to know is how hard is it to remove this housing? How many bolts is holding it to the block or how do you remove it from the block to change the o-ring seal. Ant help would be appreciated as...- 1
- 50
-
Zachchanjzx81 · updated
-
Low idle after alternator swap
MKIII (1986.5-1992)So as the title says I just recently replaced my alternator. After replacing it I started the car up and it sounded good. I looked at the rpms and it was chilling at 500. Which, after a little researching, I know is too low. Also when doing a quick rev on the engine it sounds like it's going to...- 23
- 22K
-
Exhaust Port and stud Differences
MKIII (1986.5-1992)I'm interested in building a NA-T set up. I have a "obd1" 2jzge from a 1994 SC300 and want to build a turbo kit for it. Is there exhaust port and stud differences between OBD1 OB2, vvti and non vvti heads? for example can i fit a VVTI turbo manifold on my Non VVTI Na head and so on- 4
- 114
-
Wisenot · updated
Join now to ask and comment!