Supra Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
468 Posts
Discussion Starter #1
ok i was lookign for a pic of an exhaust from behind and under the car veiws that i can take in to a shop and have them make one like it, im looking for the straight back and then bend and come out at an angle type? haha :p any pics or info would bee greatly appreciated :) thx
 

·
ƒ=1/2π(√k/m)
Joined
·
10,095 Posts
Hahaha, I'm doing the same thing... this is what I found WHEN I SEARCHED..








These are pretty good pictures for an angle on the tailpipe.

I'm probably going to use them at the shop for reference.
 

·
Registered
Joined
·
468 Posts
Discussion Starter #3
hey i did search! haha i was looking for an under so id know where exactly teh piping went
 

·
ƒ=1/2π(√k/m)
Joined
·
10,095 Posts
I remember a few of those instead.... but that wasn't my issue.. I needed a good shot of the angle.

BUT

There are some good pictures of the pipes.. I REMEMBER!



Boise boy!



Acroth's ..or friends
 
1 - 4 of 4 Posts
Top