Supra Forums banner

1 - 3 of 3 Posts

·
JZ Enthusiast
Joined
·
3,010 Posts
Discussion Starter #1
hey guys

i just finished from ETTC mod and its awsome guys .
but i got one problem tho and its the car was cutting really hard at 5k ! a little on 4200 then hardly at 5k on both ttc and seq mod but after testing and testing problem gone ! and came back and now gone! what could case that ? is it normal when u do this mod ?


thanks
ali
 

·
High Performance WorkShop
Joined
·
300 Posts
Not normal , your connections must be loose or something , make sure you solder all joints togeather and heat shrink them or tape them properly . AND check your grounding .. it might be the culprit . ^-^
 
1 - 3 of 3 Posts
Top