Supra Forums banner
1 - 14 of 14 Posts

· Registered
222 Posts
Discussion Starter · #1 · (Edited)
What is your First & Last name? Michael Start
What is your email? [email protected]
What is your phone number? -Optional: 510-427-1952
What is your City? : Union City
What is your State? : Ca
What is your Zipcode? : 94587

Email: [email protected] or call. Serious buyers only please.

1988 Toyota Supra Turbo w/ 1JZGTE


Engine: 40-60k Miles
Chassis: 104,XXX
Transmission: 40-60k R154

Title: Clean
Interior: Burgundy
Exterior: White Diamond Pearl

Motor & Transmission bought from w/ good compression w/ receipts and pictures below
Engine Mods/ Maintenance:-Driftmotion Intake
-Driftmotion Intercooler and Pipe kit
-Driftmotion Fuel bypass hose
-BIC Polyurethane Motor Mounts
-MKIV Throttle Body cable OEM
-New thermostat and gasket OEM
-New Water pump and Timing Belt OEM
-New upper and lower Radiator hoses OEM
-Greddy Downpipe
-Koyo Radiator
-Goodyear Gatorback Serpentine belt
-Goodyear Serpentine Belt tensioner
-RE-CAPED ECU from Aaron @ Driftmotion
-New Diehard Gold Battery
-TRD Radiator cap (Just purchased) *not installed
-OEM New LS400 Fan Clutch
-Tanabe Medallion Exhaust System
-Greddy Boost cut controller *Not Installed (read below: Need to Attain to section)
-New OEM Toyota Rear main seal *Not Installed (rear below: Need to Attain to section)

-AEM Wideband UEGO
-AEM Tru Boost
-Apex’I Neo w/ Apexi’ Mount
-Greddy Boost but controller
-Kenwood Headunit w/ Sub & Amp
-Kenwood Speakers Front & Rear
-89+ Climate Control

-MKIV Chrome/Polish Wheels 17”
-BRAND NEW 245/40/17 & 275/40/17 Bridgestone Potenza RE760’s
-89+ Tail Lights
-New hood props
-JDM Sticker on rear bumper (Bandaid)
-25MM Project Kics wheel spacers (Front)

-New Rack & Pinion w/ Lifetime warranty from Frast Undercar
-New Outer tie rod ends w/ Lifetime Warranty Front Fast Undercar
-Tokico Blues Struts
-H&R Lowering Springs
-Alignment recently done 3/27/09

Wiring Information/Swap Installation:
All Wiring was done by Moe (SUPRASTANGER507gte). So you know it’s done right.
Swap done by Kris (91 MK3), Moe (SUPRASTANGER507gte), Adrain, and Me =)

Need to attain to:
-Factory Boost cut @ 5500rpm's (2nd gear) **Have a Greddy Boost cut controller that I will throw in with the car. Not installed**
-Body is in good shape and so is the paint. No dents but minor dings. Also slightly faded front bumper
-Have all parts for glove box but took it out so who ever wants to buy the car can install the Greddy Boost but controller.
-Driver Seat is worn out (ripped)
-Small exhaust leak on cat *Only gasket*
-Valve cover gasket leaking

Would fix all this but school and work has got me booked!

Price: $6200 O.B.O
Reason to sell: College tuitions & bought a new house


· Registered
222 Posts
Discussion Starter · #2 · (Edited)

Will post more pictures once my photobucket comes back.

· Registered
222 Posts
Discussion Starter · #4 ·
Thanks Moe. Owe it all to you. Can't wait for your next project to be up and running with that Turbo you got! Remember if you need a hand give me a call

· Registered
222 Posts
Discussion Starter · #6 ·
yeah. I have to. =(

· Registered
222 Posts
Discussion Starter · #7 ·
UPDATE: Not leaking from rear main seal when I brought it inside the shop. Only leaking from top of valve cover gasket and dripping down to bellhousing.

· Registered
719 Posts
nice car..... good luck... btw..... my fan clutch is starting to go bad and i c ur using an ls 400 fan clutch ,,is that any better? will it fit a 7m...?.. i will eventually buy an oem from the dealer but it doesnt hurt to know...

· Registered
222 Posts
Discussion Starter · #13 ·
its in my garage! Those are for sale too =). I'll let them go for a good price.

· Registered
222 Posts
Discussion Starter · #14 ·
BUMP. Give me best offer.
1 - 14 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.