Fuel Injectors
1 - 3 of 3 Posts
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Manley rods comparison pros/cons
Naturally AspiratedI'm pretty much settled on a set of Manley H beam rods for my build but debating between the 14027-6 set and the 15027-6 (H-tuff) set. The Basic set is rated for 800whp and the cheaper set. But for about $100 more you can opt for the the H-tuff set and have a stronger 1,200whp rated set. However...- 1
- 44
-
TrueGS300 · updated
-
CR for NA-T build
Naturally AspiratedI blew my NA-T engine and am planing a rebuild/ strengthen of my engine. (GE VVTi engine) 1998 GS300. Going bonkers trying to figure out cc's of various components. I want to get away from the stock 10.5:1 ratio so I can run more than 8psi. I want to run 9.0:1 compression ideally. Is there...- 19
- 342
-
TrueGS300 · updated
-
Ali SC3's 2JZGE Na-T TT Ecu Mod
Naturally AspiratedHi everyone, this thread was started on clublexus in the sc300/400 section but it also applies to n/a supras so I copied it here. This thread might be updated less frequently than the other one, so if something isn't working or missing also check the original thread. This guide is for use of...- 100
- 31K
-
rear main seal area leak
Naturally AspiratedFirst some background on the car Freshly built motor with eagle rods/wisecos... has maybe 100 miles on it. TH400 trans (GM adapter plate/GM flexplate setup). The rear main was new when it was built. I had a leak at the rear main seal area, so I just replaced the rear main seal even though the...- 9
- 2K
-
GRANNAS · updated
-
Limits of the distributor
Naturally AspiratedI am running a NA-T sc300 with GT42-71mm, still on the distributor. I was wondering what the boost limits or what power levels the distributor starts to show its weakness? what if I added a HKS Twinpower? Current mods: th400 AEM+wb02 custom T6 exhaust mani T6 GT42-71mm sheetmetal intake...- 19
- 2K
-
GRANNAS · updated
Join now to ask and comment!