S
speedracersupra
·Guest
Joined
·
0 Posts
does anyone know the ohm setting for the gas level gauge for the mk4 twin turbo supra with stock fuel tank
gas level gauge
1 - 2 of 2 Posts
Joined
·
46,550 Posts
TERMINALS A-B =269.7
TERMINALS A-C =123.5
TERMINALS B-C =146.2
AT THE GAUGE UNIT IN THE DASH
BETWEEN TERMINALS 2 AND 3
FULL =4.0
1/2 =55.0
EMPTY =107.0
AT THE SENDING UNIT IN TANK
TERMINALS A-C =123.5
TERMINALS B-C =146.2
AT THE GAUGE UNIT IN THE DASH
BETWEEN TERMINALS 2 AND 3
FULL =4.0
1/2 =55.0
EMPTY =107.0
AT THE SENDING UNIT IN TANK
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
2jzvvti swaped into a mk3 supra
MKIV (1993-1998)I purchased a brand new wiring harness for a 2jz. After the engine swap was done I was told the throttle body had to be bypassed and the aftermarket turbo could not be tuned. What a waste! Please tell me what I need to do to be able to tune my car. Thank You, Mike C- 0
- 37
-
'97 TRD LSD Issues and intermittent P0420/P1512 Codes
MKIV (1993-1998)So I have a few issues, mostly just annoyance/nuisance issues but they all add up. I had my TRD LSD put in my car last year. I moved about a month ago. I know that a clutch type diff behaves differently but I will say that it seems more sensitive lately. I have a three-car garage and the...- 11
- 211
-
Gary Bechtold · updated
-
Ohlins Supra coilovers
MKIV (1993-1998)Hi guys, Well i just bought a set of used Ohlins coilovers for the Supra. From reading the lettering on the springs, it seems that they are 16k on the fronts and 12k on the rears. Damper and height adjustable but not sure about rebound. Seems like there is an allen key on the bottom of the...- 36
- 8K
-
Jdmsup · updated
-
Ignition Lock Cylinder Issue
MKIV (1993-1998)I cannot turn my key to start or even turn to accessories on my 95 SE. Looking at a thread from 2005 says that its likely a worn lock cylinder. The part number that Curt recommended back then is now discontinued. What are my options now in 2020 if that part is discontinued? IF I can find...- 9
- 151
-
witesoxwoz22 · updated
-
6466 .81 non divided vs 1.00 divided question
MKIV (1993-1998)i have a quick question for the turbo gurus just bought a 6466 and 10.0 cr pistons .. turbo was shipped with traditional .81 non divided housing . i am using a boostlogic divided manifold . should i be using a divided turbo housing and if so ive read elsewhere that a 1.00 divided is very close...- 22
- 4K
-
lexforlife · updated
Join now to ask and comment!