getrag question
1 - 3 of 3 Posts
Joined
·
46,550 Posts
What do you mean by the "half seals"?????
The case uses silicone sealer between the halfs.[Part#00295-01281]
You should at least replace the Input and Output shaft seals while it's out.
Input shaft seal # 90080-31037
Output shaft seal#90080-31029
Shift rod seal #90080-31032
The case uses silicone sealer between the halfs.[Part#00295-01281]
You should at least replace the Input and Output shaft seals while it's out.
Input shaft seal # 90080-31037
Output shaft seal#90080-31029
Shift rod seal #90080-31032
Joined
·
591 Posts
Curt, the shaft that goes into the rear of the tranny, that connects to the shifter shaft, is that this ? (shift rod case seal-#90080-31032[TT 6spd])???? Email me and let me know. If it is, I need it asap! Thanks bud.
Oh, btw, I just finished installing the 6spd today. It runs really well. When I checked it after about a 3 mile ride, I noticed a little bit of fluid coming out of this seal. ( An O-ring type of seal)
Lenny
Oh, btw, I just finished installing the 6spd today. It runs really well. When I checked it after about a 3 mile ride, I noticed a little bit of fluid coming out of this seal. ( An O-ring type of seal)
Lenny
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
New Wheel & Tire fitment guide.
MKIV TechnicalPlease send me an e-mail if you would like a copy of the spreadsheet. [email protected] Later, Steve- 1K
- 236K
-
Steve Jarvis · updated
-
Fuel pump controller
MKIV TechnicalIs there any cars that I could use for the fuel pump controller.- 3
- 83
-
2JZgte vvti ROD KNOCK? Valve issues! Help!! Much appreciated!
MKIV TechnicalHi guys, I think I have a f*cked motor. It sounds like spun bearing or rod knock The motor was a used JDM motor swapped in not long ago Finally got everything together to tune on AEM V2 Car with ZERO boost wastegate disconnected on STOCK twins I repeat NO BOOST After a few WOT runs it...- 7
- 3K
-
Driver Disconnect Touge
MKIV TechnicalI noticed that the car is holding my driving back, It’s missing that raw driver feedback I need to be able to go faster in corners. I’ve got polyurethane bushings for everything, some new White line sway bars, and MCA red coil overs (it has Old teins right now) coming in but I’m not sure if...- 2
- 88
-
2jzgte floods with new injectors
MKIV TechnicalHi all. I have searched thrue all threads including lexus about this and haven't found an answer. Car: 02 Lexus is300 2jzgte aristo Single turbo 6262. I recently got a apexi neo and also Bigger injectors to help with the fueling. Has an in tank walbro 255 When I installed 650cc sidefeed...- 0
- 80
-
Gennkley · updated
Join now to ask and comment!