Z
ztellan
·Guest
Joined
·
0 Posts
Hello, is there anyone who knows how to stop the airbag light from shining after installing a greddy boost gauge...
Greddy boost gauge install?
1 - 2 of 2 Posts
Joined
·
448 Posts
1 - 2 of 2 Posts
Join the discussion
Recommended Reading
-
Single turbo 2jzgte is300
MKIV TechnicalHi guys sorry to bother you on your Supra thread. But I have an 02 Lexus is300 with aristo 2jzgte single turbo swap and was hoping you guys could help me out better then lexus forums. I have a 02 lexus is300 with 2jzgte swapped engine. I recently installed a single turbo set up (6262) From...- 0
- 72
-
Gennkley · updated
-
High pitch scraping sound from rear wheel
MKIV TechnicalSo my Supra makes a high pitch sound from the (right) rear wheel every time it makes an entire spin. I think it might have something to do with the brakes because the sound goes away when I press on the brakes. Can anyone tell me what could be the problem?- 3
- 116
-
BMVic · updated
-
V161 Output Shaft Seal Removal
MKIV TechnicalHi all, trying to remove the output shaft seal on my MKIV 6 speed. I am having an absolute btch of a time getting this seal out. I've cruised pretty much the entire forum regarding this issue but couldn't find any specific tips. I've been prying on it as hard as I can with hooks, as shown in...- 1
- 85
-
Pursuit of Speed · updated
-
A340e auto stupidness
MKIV TechnicalLong post alert! :) My car is an US TT, automatic. I’ve destroyed this transmission several times, it was last rebuilt less than 5K miles ago. I’m not looking for any real power anymore, it is a single conversion but I have the boost so low I doubt it’s much higher power than BPU. The last...- 6
- 298
-
Safely installing 272 camshafts
MKIV TechnicalHey guys, I'm about to install my new BC 272 cams. I need some guidance with aftermarket cams. I'm reading 2 or even 3 different ways to install them in the forums. Which is safest incase they do make the motor interference?. Do I place crank 15deg BTDC, install the cams as per TSRM, lock...- 5
- 229
-
rallly · updated
Join now to ask and comment!