[mdr40z]

Can't seem to install it right (japanese instructions) anybody know how to do it?
Which ecu wire I get for air flow?

 

[supraman07]

this is the best i can do

http://www.google.com/language_tools

you might have to go buy a japanese translation book from books-a-million

 

[Larry_A]

Hello Old Man,
If it is the BCC:
- TPS signal wire goes to White BCC input.
- ECU TPS wire goes to Green BCC output.
- Any ignition/switched 12V source to Red BCC.
- ECU shared ground to Black BCC.

If it is a Greddy something else, I can't help.

Good luck.

 

[mdr40z]

Thanks old guy, that is different than I did, I'll try it..... It is a Speed Limit Cut Controller, I think is the same as BCC

 

[Larry_A]

Thanks old guy, that is different than I did, I'll try it..... It is a Speed Limit Cut Controller, I think is the same as BCC

BCC [Boost Cut Control] is NOT the same as a speed limiter defencer! I wasn't aware of a speed-limiter in the MkIII ECU. FWIW: The Apex-i Rev-Speed Meter has a speed limiter defencer- it just intercepts the speed signal to the ECU.

Take care.