A
ama078
·Guest
Joined
·
0 Posts
What is the best holder for gauges to match factory trim in a 94? help on gauge choice would be nice too alsop to match factory lighting and apperance thanks
guage pod?
Join the discussion
Recommended Reading
-
LSD clunking
MKIV TechnicalSo wanted some input. Found out I have a LSD in my diff A01A 200mm Believe it's a Cusco RS Issue I'm having is that when turning at low speed there is a LOUD audible clunking noise under load only. If you take the turn without load, no noise. Just replaced all bushings related to the diff...- 3
- 51
-
RHDMK4 · updated
-
1993 Supra Jza80 2jzge na-t auto, Stock ecu to haltech elite 750 ecu swap
MKIV TechnicalHi everyone, I have been searching for the last week with no success at all on this particular subject. I have a 1993 Supra jza80, 2jzge non vvti, 340 auto trans & its a Japanese spec rhd car. I have removed eng, eng loom, ecu & trans. I have purchased all the parts I need for long block build...- 0
- 44
-
1OWN8 · updated
-
need help with the RPM wire from ECU loom.
MKIV Technicalhi guys i need help with locate the 2jzgte RPM wire from the wire harness from ECU . a buddy helping me installing microtech system. he asked me which one is the RPM wire. i did a search i get either pin 58 on B HARNESS or pin 16 on E10 A HARNESS. the car is a J spec right hand side with...- 0
- 32
-
Both 2 gear and L gear lights on at same time, Random MANU light, Auto Lockout
MKIV TechnicalCar is stock with 215k miles and is a 94 Turbo model. I have the random manu light with automatic shift lockout. This is coupled with another strange phenomenon in which both green lights on the dash under the tachometer for 2 gear and L gear will illuminate simultaneously if the shifter is in...- 2
- 194
-
No power to fuel pump
MKIV TechnicalI have no power to fuel pump or diagnostic. I know I get power from efi main relay. Bench tested relay and I good. Checked resistance for ground and that is good. But voltage coming from the ECU is only putting out about 7 volts to the relay which isn’t enough to kick over the relay coil...- 8
- 172
Join now to ask and comment!