[Whodiisb]

ok i have just replaced my mk3 7mge motor and it only has about 2k miles on it...and a new clutch and everything at that, but now the clutch seems like it doesnt have as much hydraulic fluid and the pedal is sticking to the floor and acting up and yes this is a brand new clutch! i have lost my repair manual and any help would be much appericated! thanks every one so much..and another thing im leaking oil and trany oil like a biotch...new gaskets and every thing any ideas?

 

[Trent]

For the clutch, the master cylinder is probably leaking. Very common in these cars. Check the fluid level and check the inside of the firewall where the clutch pedal is. It probably has fluid on it. If it's not that, then bleed the clutch and make sure no air is in there.

For the oil and tranny, it could be anywhere. Get under there and find out where its coming from.

 

[AGlobalThreat]

Clutch master cylinder and the rod?

 

[Whodiisb]

i just replaced the master cylinder...?

 

[DaleH]

Hmmm sticking to floor usually means LOTS of air in the line, or your bleeder valve on the Slave Cylinder has loosened up. Is it hard to go into gears or shift while driving? Where under the tranny is it leaking this oil? I would try to rebleed your clutch first, then see what happens.

Dale

 

[AGlobalThreat]

When u swap the master cylinder you MUST bleed the clutch

 

[Whodiisb]

ooohhh u must bleed the clutch hahah whoops better bleed it lol thanks every one..!

 

[2damaxsupra]

could be ur slave cylinder, when master goes slave follows

 

[SupraMkiii24]

hahaha, well there's the mistake .