Supra Forums banner

1 - 6 of 6 Posts

·
VIPER HUNTER
Joined
·
835 Posts
Discussion Starter #1
Ok non turbo automatic supra.

Put a 7mgte in it jspec,right now it has a header on it,and all the na electronics(mass air,coil,distributer,ecu)

car dosent run,it turns over gurgles a second but thats it.
I put a new mass air flow on it,and it started,ran for like 2 minutes fine then stalled and wouldnt start up again.

Car will run with starting fluid being sprayed in it.
 

·
Registered
Joined
·
3,249 Posts
sounds like the ECM is shutting off the engine. perhaps it's losing power on wire that it shouldn't? or not receiving a signal it should?
 
S

·
Guest
Joined
·
0 Posts
slowyoda89 said:
Car will run with starting fluid being sprayed in it.
Sounds like a fuel issue.

Use a paper clip, and jump the +B and Fp terminals in the diagnosis connector, see if it will run that way.

Also check your trouble codes, it may reveal something.
 

·
VIPER HUNTER
Joined
·
835 Posts
Discussion Starter #6
checked the trouble codes,all i got is two blips.

guy tells me he gets it passed 3gs and it goes fine,and if he would hold it at 3gs once he got it running with starting fluid it would stay running if he held it a 3 grand
 
1 - 6 of 6 Posts
Top