Supra Forums banner

1 - 4 of 4 Posts
C

·
Guest
Joined
·
0 Posts
Discussion Starter #1
Guys,

I recently bought the HKS Hyper Damper kit from this person, however, there was no instructions on how to adjust the height and damper.

How do I adjust the height? The current setup is too low for my vehicle, in order for me to lift the vehicle about 1/2 inch, do I turn clockwise? or counterclockwise?

Also, how do I adjust the damper? The rear ones have the metal thing sticking out and I could turn the metal thing to adjust the damper however, how do I make the ride firmer? turning clockwise or counterclockwise? And the front ones do not have anything to adjust the damper with, how do I adjust the front damper?

Thanks in advance.

Peter~
 

·
boost is good
Joined
·
772 Posts
to raise the height of the car turn it clockwise

as far as the dampering, ide guess to make it less firm you would losen the valve, or counterclockwise.

i dont have these coilovers so u might want to check with someone that does but this is the general way that it goes.
 

·
Registered
Joined
·
30 Posts
To adjust the damping you use the allen key and turn it clockwise to make it stiffer. You adjust the front and back the same way.

cupete said:

Also, how do I adjust the damper? The rear ones have the metal thing sticking out and I could turn the metal thing to adjust the damper however, how do I make the ride firmer? turning clockwise or counterclockwise? And the front ones do not have anything to adjust the damper with, how do I adjust the front damper?

Thanks in advance.

Peter~
 
C

·
Guest
Joined
·
0 Posts
Discussion Starter #4
Thanks guys,

I was able to adjust the damper with Allen tool. I have one other question about the rear shocks.

My front Hyper Damper II ( I found this out when I was turning, 30 clicks... WOW) are good however, my rear ones will make annoying noises when going over potholes. By making the coilover stiffer, will this noise go away? Any ideas?

Thanks,

Peter~
 
1 - 4 of 4 Posts
Top