Joined
·
3,276 Posts
whats up with search? it kept telling me i didnt enter enough letters to equal the minimum length...i typed like 40 or so characters...so whats up with that? is it broken or do you have to type a friggen lot?
Bob
Bob
Is the Search feature broken or am i just a [email protected]$$
1 - 3 of 3 Posts
Joined
·
1,822 Posts
What did you try searching for? I think the normal minimum length is 2 or 3. Maybe yours was a special case 
Joined
·
3,276 Posts
must've been
now its working fine again....go figure
now its working fine again....go figure
1 - 3 of 3 Posts
Join the discussion
Recommended Reading
-
Waste-gate stuck open?
Naturally AspiratedI'm pretty sure this is a no brainier, but I had my car running up in the air on a lift after doing some repairs and inspecting. I noticed that the dump tube off of my waste-gate is puffing. Am I right to assume that the waste gate should not let anything past until it's spring pressure is...- 9
- 89
-
TrueGS300 · updated
-
IS300 Coil Pack brackets for NA Supra?
Naturally AspiratedHi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)- 5
- 277
-
NA-T high increasing idle after IS300 coil pack conversion AEM v1
Naturally AspiratedHi Supraforum'ers, Has anyone experienced a high idle 2500 rpm + (that keeps increasing) after you converted from distributor to the IS300 coil packs with AEM EMS v1 (or similar engine management system)? I set the base ignition timing with AEMPower's wizard, and made sure the throttle body...- 7
- 334
-
Fuel pressure
Naturally AspiratedI just got my return fuel system finished up and am having an issue with setting fuel pressure. I ran a Walbro 525 pump with an 8an feed and 6 an return. FuelLab regulator on the return, with a Radium Engineering gauge. All parts high quality. I can't get the gauge to read past 20psi. The car...- 6
- 158
-
TrueGS300 · updated
-
TPS calibration
Naturally AspiratedOkay, so I have read the tsrm for the calibration method and was wondering how exactly to apply that to an aftermarket ffim with an RMR 90mm throttle body. Am I even using the right TPS sensor? I have the factory 2jzge (cali spec) TPS sensor on the car. The issue I'm having is uncontrollable...- 14
- 781
Join now to ask and comment!