Supra Forums banner
1 - 5 of 5 Posts

·
REVTECHRACING.COM
Joined
·
2,675 Posts
Discussion Starter · #1 ·
somehow i missplaced the 2 oil feed washers on the side of the block. i have the bolts but no banjo washers. along with that i lost the 2 nuts that hold the oil return line on at the bottom of the oil pan.along with the gasket too. any part numbers for these or can i go to a part store and buy them? also can i use the fipg gasket stuff i have left over as a gasket for the lower return line braket? thread size and banjo /washer size? thanks curt. :bigthumb:
 

·
Premium Member
Joined
·
46,548 Posts
A ] 90430-12026 Gasket Oil Feed List 1.18 Cost 0.87 Ea X 4
B ] 90080-17242 Nut, List 1.43 Cost 1.06 Ea X 2
C ] 15472-46010 Gasket, Return List 3.94 Cost 2.92

A] Bring The Banjo Bolt With You To A Parts Store And See If They Have A Brass/aluminum Washer To Fit It.

B] 8mm Nut

C] You Can Used Fipg If Needed, Make Sure It Sets Up Over Night So You Dont Have Any Leaks
 

·
REVTECHRACING.COM
Joined
·
2,675 Posts
Discussion Starter · #3 ·
thank you sir...if i cant find ill order from you in the morning..
 

·
REVTECHRACING.COM
Joined
·
2,675 Posts
Discussion Starter · #4 ·
curt i wound up getting a copper brake line washer for the 2 oil feed lines that fit well and crush down like the stockers. if it can hold brake line pressure i assume it can my oil pressure with no leaks. i hope that is. they didnt have brass/aluminum show i went with the common copper 1. thank you again.
 
1 - 5 of 5 Posts
Top