Little black box under the car *left front wheel*

1 - 1 of 1 Posts

StaticX313

Guest

Joined Jan 1, 1970

0 Posts

Discussion Starter • #1 • Jan 27, 2002

What the hell is this thing? It keeps falling down. It can latch, but it just kinda hangs there most the time. Its right in front of the left front tire and it is a black box. Just tryin to figure out what the heck it is lol thanks

Rob~

1 - 1 of 1 Posts

Recommended Reading

Waste-gate stuck open?

Naturally Aspirated

I'm pretty sure this is a no brainier, but I had my car running up in the air on a lift after doing some repairs and inspecting. I noticed that the dump tube off of my waste-gate is puffing. Am I right to assume that the waste gate should not let anything past until it's spring pressure is...
- 9
- 89
- TrueGS300 · updated 5 h ago
IS300 Coil Pack brackets for NA Supra?

Naturally Aspirated

Hi supraforum'ers, Does anyone know where I can buy some simple brackets that secure the IS300 coil packs in our non-vvti 2JZ-GE engines? I performed this coil pack conversion from a distributor cap and am planning a road trip, so I prefer them to be bolted down in a secure manner. :)
- 5
- 277
- W
  WarIsHate · updated 5 h ago
NA-T high increasing idle after IS300 coil pack conversion AEM v1

Naturally Aspirated

Hi Supraforum'ers, Has anyone experienced a high idle 2500 rpm + (that keeps increasing) after you converted from distributor to the IS300 coil packs with AEM EMS v1 (or similar engine management system)? I set the base ignition timing with AEMPower's wizard, and made sure the throttle body...
- 7
- 334
- W
  WarIsHate · updated 2 d ago
Fuel pressure

Naturally Aspirated

I just got my return fuel system finished up and am having an issue with setting fuel pressure. I ran a Walbro 525 pump with an 8an feed and 6 an return. FuelLab regulator on the return, with a Radium Engineering gauge. All parts high quality. I can't get the gauge to read past 20psi. The car...
- 6
- 158
- TrueGS300 · updated 3 d ago
TPS calibration

Naturally Aspirated

Okay, so I have read the tsrm for the calibration method and was wondering how exactly to apply that to an aftermarket ffim with an RMR 90mm throttle body. Am I even using the right TPS sensor? I have the factory 2jzge (cali spec) TPS sensor on the car. The issue I'm having is uncontrollable...
- 14
- 781
- M
  merlin33bc · updated 4 d ago