Supra Forums banner

1 - 4 of 4 Posts

·
Registered
Joined
·
972 Posts
Discussion Starter #1
I remember in the old groups a couple people had lapping blocks and a box a shims if people needed them. I am looking for those two items as I have an engine about to hit the machine shop.

If someone has these two items I would like to be able to borrow/ rent them from you. If you could get in contact with me we can figure it out. I will cover shipping and discuss use of these items.

Richard long
[email protected]
 

·
greasemonkey
Joined
·
3,125 Posts
i actually posted a thread awhile back on where the block/head lapping tool can be purchased, and received no response. The RCTS site does not list the tool any longer.
 

·
7M Fanatic
Joined
·
3,266 Posts
I bought my lapping plate off eBay in the industrial section.
But it weighs over 60 pounds, and have no intentions of trying to ship it.

I do have over 300 7M shims.
Used to exchange them for $1 each + shipping, but since some people don't know how to measure, and/or have cheap-ass measuring tools, I don't do that any more.
But if someone wanted to take the whole works off my hands, including the Matco shim changing tools, I'm open to offers.
 
1 - 4 of 4 Posts
Top